Viewing parameters of existing step for the PO-20?

Pocket Operators
#1

Hi Again,


Welp ya’ll should have known better than to so thoroughly and helpfully answer my last question, because I’m back with another one ;P. Pretty sure the answer to this one is “you can’t”, but we’ll see.

Once you’ve programmed in a step sequence, is it possible to view the A/B parameters of that particular step? In particular I’d like to know the note parameters of an existing step. Handy if I’m doubling a sequence to another instruments.

Right now I am just figuring it out by ear, my pitch is not so great, but I can usually get it but leaving write mode and trying to re-create the melody my ear while live playing.

But it’s just a little slow cumbersome.

Anyway I don’t think it’s possible to view existing step parameters, but just in case thought I’d ask!

Thanks



#2

Hey there.

As far as i know, there is no way to do it other than what you’re already doing instead.

Keep at it though, as you’ll improve your “musical ear”.


#3

Slow it down and play it to a tuner?


Or record it into Logic Pro X and use flex pitch?

There will be many other similar ways, but perhaps not close enough to what you’re looking for.

CB


#4

Okay, thanks folks!